The movement of nutrients into the vascular stele requires energy, unlike the movement of water that does not require energy. This energy is provided by the phloem. Sugars are produced in the leafs, as part of the photosynthesis process, so whenever a new root is growing, or a fruit needs to grow, the phloem gets in action. With the help of the water the sugars get in the phloem, which can most simply be seen as an elevator inside the plant, that is moving nutrients up and down, on the places in which they are most needed.
The question should be about active vs passive range of motion.
In the active range of motion, the test is done by asking the patient to move their body themselves. In this case, the patient should use their muscle to move their body. If there is a restriction in this examination, it could be caused by the muscles or the joints, or the nervous system that used to contract the muscle.
In the passive range of motion, the test is done by the examiner moving the patient body. Since no muscle used, the test shouldn't be influenced much by the muscle. Then, if there is an articular joint issue, the restriction would be found in both passive and active ROM, but the nonarticular joint issue might only cause abnormality in the active ROM.
Answer:
Steroid hormones that enter the cell activate receptors. These hormone-receptor complexes then bind HREs and influence gene expression.
Explanation:
Mechanism of action of steroid hormones is as follows:
- Steroid hormone enters cell and bind to the receptor.
- Translocation of activated receptor- ligand complex into nucleus.
- This complex then bind to another receptor on the chromatin.
- Steroid receptors form dimers.
- Act on DNA
- These hormone-receptor complexes then bind HREs and influence gene expression.
- Augmentation or Suppression of transcription.
Answer:
to prevent other buds from growing, allowing the plant to grow taller ... Which of the following is an example of genetic engineering that occurred ... In creating golden rice, Potrykus and Beyer needed to insert genes that would make the ... During which stage of genetic engineering does the scientist add DNA pieces
Explanation:
Answer:
To determine the flask on basis of the molarity or concentration of the solutions, an individual should design an experiment with the help of using water and dialysis tubes. Dialysis tubes up should be filled with pure water, then seal or closed them from both ends.
Measure the weight and note the mass of each tube, student should stick label the cups with the solutions. Weighing the solutions after leaving them for 8 to 10 hours. The tubes would lose weight as water leave the tube when placed in the solutions due to the principle of diffusion- movement.
