From oldest to youngest: I, B, F, M, R, H.
Explanation:
On the picture we can see several layers of rock. Some of the layers have not been disturbed, so the principle of superposition can be applied to them. Some of the layer though have been disturbed by geological processes, so the layers are not at the same level because of it. On top of it, there is also an intrusion that has managed to further cause disturbance through all of the layers.
- The layer I is the oldest, and it is the basis of the others.
- Layer B has formed next, and after that layer F.
- These three layers have been influenced by the formation of fault, where one of their sides has been moving up relative to the other, while the other has been moving down relative to the other.
- Layer M is younger layer, and it can easily be seen as it totally covers the layer F below it.
- On top is layer R, which is the youngest of them all (the layers), and the one that comes out on the surface.
- Layer H is not really a layer, but it is an intrusion, which has formed after magma managed to cut through all the layers and later solidify. It is the youngest formation.
Learn more about intrusive and extrusive rocks brainly.com/question/10413835
#learnwithBrainly
Answer:
Mid latitude cyclone are low pressure regional cyclone system formed in 30 to 55 N or S. In this region continental polar and tropical air masses collide to form fronts. Fronts are the boundary between two air masses. This front pushes the warm air to the north and cold air to the south and generating a clockwise rotation. Cyclone starts to form from southwest and reaches mature stage to form a well developed cold front and warm front.This cyclone become weak, both cold and warm front merge as occluded front, this causes the snow and poor weather condition in northeast US, same time southwest is the formation zone, so mild temperature.
The difference in elevation in meters between the points X and Y is 360.
Explanation:
On the presented map we can see that the relief is depicted with contour lines. The contour lines are marked with their elevations, or rather the main contour lines are, every fifth one. We also have the contour interval, which is 20 meters, thus giving us the basis so that we can find the difference in elevation between any points on the map.
What we know for sure from the map is:
- the elevation is increasing from southeast toward northwest
- the difference in elevation between the contour lines is 20 m
- the difference in elevation between the main contour lines is 100 m
Point X is marked on the contour line of 1,600 m. Point Y is marked on the second contour line between the 1,200 m and 1,300 m contour lines, thus:
2 x 20 = 40
So we have 1,240 m. Having the elevations of the two points, we only need to take the lower value from the larger value:
1,600 - 1,240 = 360 m
So we get a result of 360 m of difference in elevation between the points X and Y.
Learn more about contour lines brainly.com/question/1972242
#learnwithBrainly
Mohamed and Li Jing were asked to find an explicit formula for the sequence -5\,,-25\,,-125\,,-625,...−5,−25,−125,−625,...Minus,
ANTONII [103]
Answer:
the equation is given as 
Explanation:
As the sequence is given as −5,−25,−125,−625,...
From this the first term is given as
a1=-5
Now the relation between this term and the next term is to be observed.
d=a2-a1=-25-(-5)=-25+5=-20
d=a3-a2=-125-(-25)=-125+25=-100
Now it is observed that the difference is not same this indicates that the relation is not arithmetic.
next up is the geometric sequence so the value of ratio is given as
r=a2/a1=-25/-5=5
r=a3/a2=-125/-25=5
As the ratio is same this indicates, this is a geometric sequence.
Now for the geometric sequence, the value of the general term is given as

Here a1=-5 and r=5 so the equation is given as

Answer:
A Meteorologist analyzes weather patterns and predicts weather events.
Meteorology is the study of the atmosphere, focusing on weather forcasting. Therefore the only option that makes sense is, "analyzes weather patterns and predicts weather events"
Explanation: