Answer:
When the level of release of carbon dioxide during respiration and use of carbon dioxide during photosynthesis this results in a compensation point. At compensation point the net available carbon dioxide to phototrophs becomes zero. As, carbon dioxide is the chief ingredient for photosynthetic products like glucose and oxygen. These products are used up during the process of respiration. When the rates of two processes photosynthesis and respiration becomes equal. Phototrophic organisms will not be able to compensate for lack of carbon dioxide levels. Phototrophs will not be able to produce their food in the form of glucose and hence will not be able to respire too. This will result in lack of overall available food from phototrophs and lack of available oxygen for respiration. This will result in decline of organisms on earth.
<span>The specific heat of the metal is 0.5 cal/ (0C.g). This means the energy needed is 0.5 cal to raise the heat of 1 gram of metal by 1 degree C. Therefore, the energy needed to raise 100 g of the metal by 20 degrees C is:
0.5 * 20 * 100 = 1000 cal.
</span>
The letter should contain concerns about the causes and ill effects of erosion.
<h3><u>Explanation</u>:</h3>
Sir,
I am very sad to inform you that the town of Hariharanpur is suffering from continuous erosion for the last 3 years. Even after having proper knowledge about this fact, you being the mayor, are not taking any charge of this situation.
The town is situated just by the side of River Ganges which makes it's soil full of moisture. Along with the repeated deforestation and tree cutting for urbanisation, the smallest of the rain falls are also eroding a lot of soils. This can lead to severe landslides in river Ganges with severe loss of properties as well as loss of lives too.
So i request you to start embanking the river as well as to start planting new trees to save the town from getting lost under Ganges.
Thanking you,
XYZ.
Answer:
To determine the flask on basis of the molarity or concentration of the solutions, an individual should design an experiment with the help of using water and dialysis tubes. Dialysis tubes up should be filled with pure water, then seal or closed them from both ends.
Measure the weight and note the mass of each tube, student should stick label the cups with the solutions. Weighing the solutions after leaving them for 8 to 10 hours. The tubes would lose weight as water leave the tube when placed in the solutions due to the principle of diffusion- movement.
