Answer:
// The code segment is written in C++ programming language
// The code segment goes as follows
for (k = 0; k < nMembers; k++)
{
//check if memberID can be found in currentMembers
if (currentMembers[k] == memberID){
// If yes,
// assigns true to isAMember
isAMember = true;
k = nMembers;
}
else{
isAMember = false;
// If no
// assigns false to isAMember
}
}
// End of segment:
The following assumption were made in the code segment above.
There exists
1. An already declared and initialised int array currentMembers.
2. An already initialised int variable memberID
Line 3 initiates a loop to scan through the array
Line 6 checks for the condition below
If current element of array equals memberID then
It assigns true to isAMember and nMembers to k
Else
It assigns false to isAMember
Harry would need to change the "color scheme" to change the background of all his presentation slides.
Answer:
Explanation:
<u>Ways to Avoid Scope Creep</u>
Scope creep is what happens when changes are made to the scope of a project without any control. Changes happen to projects all the time without been notify ontime as a project manager. It is that very rare project that ends up delivering exactly what was asked for on the first day. However, without there being some control over the changes, a project manager has little chance of keeping on top of the work and managing the project effectively.
Generally, scope creep is when new requirements are added after the project has commence. These changes are not properly reviewed. The project team is expected to deliver them with the same resources and in the same time as the original scope.
On the other hand, as a project manager you could end up with a project with lots of approved, considered changes, that never ends because every time you think you have finished a new requirement arrives in your inbox and you have to make more changes.
The following are five ways to keep control of your project.
<em>1-Document the Requirements</em>
<em>2-Set up Change Control Processes</em>
<em>3-Create a Clear Project Schedule</em>
<em>4-Verify the Scope with the Stakeholders</em>
<em>5-Engage the Project Team</em>
<span>The c++ operator delete is used to destroy dynamic variables.</span>
Answer:
(1) Carry flag (2) Overflow flag (3) Sign or negative Flag
Explanation:
Solution
(1) The carry flag : It refers to the adding or subtracting. a two registers has a borrow or carry bit
(2) The over flow flag: This flag specify that a sign bit has been modified during subtracting or adding of operations
(3) The sign flag: This is also called a negative sign flag is a single bit status in a register that specify whether the last mathematical operations generated a value to know if the most significant bit was set.