Two steps that could be taken to reduce water usage and promote conservation are:
1. Provide incentives to households or companies who have reduced their water usage over time.
2. Reducing the cost of water conservation and recycling technologies.
These methods will be successful as companies and households can see reduced bills or other incentives if conservation methods are employed. Reducing the cost of conservation technologies ensures access to a wider section of the population. <span />
Answer:
B.) Red Volcanic Rock
C.) Lava Rock covered by Sulphur
Explanation:
Igneous rocks are rocks that forms from the cooling and solidification of magma. Magma is a melt or molten rock. Magma is usually derived from rocks that have been buried and subjected to extreme temperature conditions.
Red volcanic rocks and lava rocks covered with sulphur are classified as volcanic rocks. Volcanic rocks are formed from magma that settles and cools on the surface of the crust. These magma is called lava.
Slate is a metamorphic rock and sandstones are sedimentary in nature.
Out of the following choices, the following factors that the city planner should consider after what happened to New Orleans after Hurricane Katrina hit are the city's position near a large river or gulf, the city;s location near a deep water harbor, and the city's elevation above sea level.
The Australia – United States Free Trade Agreement (AUSFTA) is a preferential trade agreement between Australia and the United States modelled on the North American Free Trade Agreement (NAFTA). TheAUSFTA was signed on 18 May 2004 and came into effect on 1 January 2005. On the other hand, tThe United States–Israel Free Trade Agreement is a trade pact between the State of Israel and the United States of America established in 1985 that lowered barriers to trade in some goods. And lastly, the North American Free Trade Agreement is an agreement signed by Canada, Mexico, and the United States, creating a trilateral trade bloc in North America.<span>
</span>
The Forestry Department is using a <u>chemical</u> control method. This involves using a <u>foliar spray </u>method, in which department personnel will spray pesticide directly on the trees’ leaves.
Explanation:
The chemical control method of pesticide control involves spraying chemical pesticides directly on leaves, shoots or roots of the plants. These chemicals are toxic to the pests only and the pests get retracted from the plants because of the pesticides applied.
A selective pesticide application is done to limit application to a target harmful pest which kills only that and does not harm the other useful or harmless species which thrives on the plants.
White pine blister causes rust of the branches and leaves of the pine trees. Hence, a foliar spray of the pesticide is done to control its spread.
