Ask question

Ask question

All categories

2 years ago

13

A glass of cold milk sometimes forms a coat of water on the outside of the glass (often referred to as ‘sweat'). how does most o

f the water get there?

1 answer:

PolarNik [594]2 years ago

4 0

It is from condensation from the air where the glass of cold milk is.

You might be interested in

A food web showing the flow of energy through a freshwater ecosystem is shown below. Which of the animals shown in the food web

kati45 [8]

Answer: minnows

Explanation: tiny fish

7 0

2 years ago

Read 2 more answers

The initial temperature of the water in a constant-pressure calorimeter is 24°C. A reaction takes place in the calorimeter, and

kupik [55]

Answer:

Explanation:

For a chemical reaction, the enthalpy of reaction (ΔHrxn) is … ... to increase the temperature of 1 g of a substance by 1°C; its units are thus J/(g•°C). ... Both Equations 12.3.7 and 12.3.8 are under constant pressure (which ... The specific heat of water is 4.184 J/g °C (Table 12.3.1), so to heat 1 g of water by 1 ..

8 0

2 years ago

Read 2 more answers

What mass of AgBr can be produced starting with 34.3G of NaBr? (Stoichiometry method)

olga nikolaevna [1]

The equation is already balanced so the mole ratio is just 1/1 and from the question you could conclude that the equation is a single displacement

5 0

2 years ago

The unit cell for cr2o3 has hexagonal symmetry with lattice parameters a = 0.4961 nm and c = 1.360 nm. If the density of this ma

IRINA_888 [86]

To calculate the packing factor, first calculate the area and volume of unit cell.

Area is calculated as:

$A=6R^{2}\sqrt{3}$

Here, R is radius and is related to a as follows:

$R=\frac{a}{2}$

Putting the value in expression for area,

$A=6(\frac{a}{2})^{2}\sqrt{3}=1.5a^{2}\sqrt{3}$

The value of a is 0.4961 nm

Since, $1 nm=10^{-7}cm$

Thus, $0.4961 nm=4.961\times 10^{-8} cm$

Putting the value,

$Area=1.5(4.961\times 10^{-8}cm)^{2}\sqrt{3}=6.39\times 10^{-15}cm^{2}$

Now, volume can be calculated as follows:

$V=Area\times c$

The value of c is 1.360 nm or $1.360\times 10^{-7} cm$

Putting the value,

$V=(6.39\times 10^{-15}cm^{2})\times (1.360\times 10^{-7} cm)=8.7\times 10^{-22}cm^{3}$

now, number of atom in unit cell can be calculated by using the following formula:

$n=\frac{\rho N_{A}V_{c}}{A}$

Here, A is atomic mass of $Cr_{2}O_{3}$ is 151.99 g/mol.

Putting all the values,

$n=\frac{(5.22 g/cm^{3})(6.023\times 10^{23} mol^{-1})(8.7\times 10^{-22}cm^{3})}{(151.99 g/mol)}\approx 18$

Thus, there will be 18 $Cr_{2}O_{3}$ units in 1 unit cell.

Since, there are 2 Cr atoms and 3 oxygen atoms thus, units of chromium and oxygen will be 2×18=36 and 3×18=54 respectively.

The atomic radii of $Cr^{3+}$ and $O^{2-}$ is 62 pm and 140 pm respectively.

Converting them into cm:

$1 pm=10^{-10}cm$

Thus,

$r_{Cr^{3+}}=6.2\times 10^{-9}cm$

and,

$r_{O^{2-}}=1.4\times 10^{-8}cm$

Volume of sphere will be sum of volume of total number of cations and anions thus,

$V_{S}=V_{Cr^{3+}}+V_{O^{2-}}$

Since, volume of sphere is $V=\frac{4}{3}\pi r^{3}$ ,

$V_{S}=36\left ( \frac{4}{3}\pi (r_{Cr^{3+})^{3}} \right )+54\left ( \frac{4}{3}\pi (r_{O^{2-})^{3}} \right )$

Putting the values,

$V_{S}=36\left ( \frac{4}{3}(3.14) (6.2\times 10^{-9} cm)^{3}} \right )+54\left ( \frac{4}{3}(3.14) (1.4\times 10^{-8} cm)^{3}} \right )=6.6\times 10^{-22}\times 10^{-8}cm^{3}$

The atomic packing factor is ratio of volume of sphere and volume of crystal, thus,

$packing factor=\frac{V_{S}}{V_{C}}=\frac{6.6\times 10^{-22}cm^{3}}{8.7\times 10^{-22}cm^{3}}=0.758$

Thus, atomic packing factor is 0.758.

6 0

2 years ago

Read 2 more answers

When heating a flammable or volatile solvent for a recrystallization, which of these statements are correct? More than one answe

otez555 [7]

Explanation:

A volatile substance is defined as the substance which can easily evaporate into the atmosphere due to weak intermolecular forces present within its molecules.

Whereas a flammable substance is defined as a substance which is able to catch fire easily when it comes in contact with flame.

Hence, when we heat a flammable or volatile solvent for a recrystallization then it should be kept in mind that should heat the solvent in a stoppered flask to keep vapor away from any open flames so that it won't catch fire.

And, you should ensure that no one else is using an open flame near your experiment.

Thus, we can conclude that following statements are correct:

You should heat the solvent in a stoppered flask to keep vapor away from any open flames.

You should ensure that no one else is using an open flame near your experiment.

3 0

2 years ago