Answer and Explanation:
The answer is attached below
Answer:
D) AND gate.
Explanation:
Given that:
A certain printer requires that all of the following conditions be satisfied before it will send a HIGH to la microprocessor acknowledging that it is ready to print
These conditions are:
1. The printer's electronic circuits must be energized.
2. Paper must be loaded and ready to advance.
3. The printer must be "on line" with the microprocessor.
Now; if these conditions are met the logic gate produces a HIGH output indicating readiness to print.
The objective here is to determine the basic logic gate used in this circuit.
Now;
For NOR gate;
NOR gate gives HIGH only when all the inputs are low. but the question states it that "a HIGH is generated and applied to a 3-input logic gate". This already falsify NOR gate to be the right answer.
For NOT gate.
NOT gate operates with only one input and one output device but here; we are dealing with 3-input logic gate.
Similarly, OR gate gives output as a high if any one of the input signals is high but we need "a HIGH that is generated and applied to a 3-input logic gate".
Finally, AND gate output is HIGH only when all the input signal is HIGH and vice versa, i.e AND gate output is LOW only when all the input signal is LOW. So AND gate satisfies the given criteria that; all the three conditions must be true for the final signal to be HIGH.
To resolve this problem we have,

is unknown.
With these dates we can calculate the Flexural strenght of the specimen,

After that, we can calculate the flexural strenght for the square cross section using the previously value.

Properties of Carpenter's hammer possess
Explanation:
1.The head of a carpenter's hammer should possess the impact resistance, so that the chips do not peel off the striking face while working.
2.The hammer head should also be very hard, so that it does not deform while driving or eradicate any nails in wood.
3.Carpenter's hammer is used to impact smaller areas of an object.It can drive nails in the wood,can crush the rock and shape the metal.It is not suitable for heavy work.
How hammer head is manufactured :
1.Hammer head is produced by metal forging process.
2.In this process metal is heated and this molten metal is placed in the cavities said to be dies.
3.One die is fixed and another die is movable.Ram forces the two dies under the forces which gives the metal desired shape.
4.The third process is repeated for several times.
Answer:
Max shear = 8.15 x 10^7 N/m2
Explanation:
In order to find the maximum stress for a solid shaft having radius r, we will be applying the Torsion formula which can be written as;
Allowable Shear Stress = Torque x Radius / pi/2 x radius^4
Putting the values we have;
T = 2000 N/m
Radius = Diameter/2 = 0.05 / 2 = 0.025 m
Putting values in formula;
Max shear = 2000 x 0.025 / 3.14/2 x (0.025)^4
Max shear = 8.15 x 10^7 N/m2