Answer: I'd say (B) Two months
Explanation: Hope its correct and helps, Good luck :)
Answer:
A. Firewall
Explanation:
A firewall is a network security device that monitors incoming and outgoing network traffic and decides whether to allow or block specific traffic based on a defined set of security rules.
Firewalls have been a first line of defense in network security for over 25 years. They establish a barrier between secured and controlled internal networks that can be trusted and untrusted outside networks, such as the Internet.
A firewall can be hardware, software, or both.
-Cisco
The primary reason that you would import data into a database is because the data already exists somewhere else.
As an example, you may have a spreadsheet that contains names and telephone numbers of a group of people. It is much faster to import this data into a database instead of manually entering the information.
Answer:
For 32 bits Instruction Format:
OPCODE DR SR1 SR2 Unused bits
a) Minimum number of bits required to represent the OPCODE = 3 bits
There are 8 opcodes. Patterns required for these opcodes must be unique. For this purpose, take log base 2 of 8 and then ceil the result.
Ceil (log2 (8)) = 3
b) Minimum number of bits For Destination Register(DR) = 4 bits
There are 10 registers. For unique register values take log base 2 of 10 and then ceil the value. 4 bits are required for each register. Hence, DR, SR1 and SR2 all require 12 bits in all.
Ceil (log2 (10)) = 4
c) Maximum number of UNUSED bits in Instruction encoding = 17 bits
Total number of bits used = bits used for registers + bits used for OPCODE
= 12 + 3 = 15
Total number of bits for instruction format = 32
Maximum No. of Unused bits = 32 – 15 = 17 bits
OPCODE DR SR1 SR2 Unused bits
3 bits 4 bits 4 bits 4 bits 17 bits
