answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Sindrei [870]
2 years ago
10

On your first day at work as an electrical technician, you are asked to determine the resistance per meter of a long piece of wi

re. The company you work for is poorly equipped. You find a battery, a voltmeter, and an ammeter, but no meter for directly measuring resistance (an ohmmeter). You put the leads from the voltmeter across the terminals of the battery, and the meter reads 13.0 V. You cut off a 20.0 m length of wire and connect it to the battery, with an ammeter in series with it to measure the current in the wire. The ammeter reads 7.60 A. You then cut off a 40.0 m length of wire and connect it to the battery, again with the ammeter in series to measure the current. The ammeter reads 4.50 A. Even though the equipment you have available to you is limited, your boss assures you of its high quality: The ammeter has very small resistance, and the voltmeter has very large resistance. What is the resistance of 1 meter of wire?
Physics
1 answer:
Lostsunrise [7]2 years ago
3 0

Answer:

0.06\Omega/m

Explanation:

Firstly, when you measure the voltage across the battery, you get the emf,

E = 13.0 V

In order to proceed we have to assume that the voltmeter offers no loading effect, which is a valid assumption since it has a very high resistance.

Secondly, the wires must be uniform. So the resistance per unit length is constant (say z). Now, even though the ammeter has very little resistance it cannot be ignored as it must be of comparable value/magnitude when compared to the wires. This is can seen in the two cases when currents were measured. Following Ohm's law and the resistance of a length of wire being proportional to it's length, we should have gotten half the current when measuring with the 40 m wire with respect to the 20 m wire (I=\frac{V}{R}). But this is not the case.

Let the resistance of the ammeter be r

Hence, using Ohm's law we get the following 2 equations:

\frac{13}{20z+r} =7.6   .......(1)

\frac{13}{40z+r} =4.5     ......(2)

Substituting the value of r from (2) in (1), we have,

13=152z+7.6\times\frac{13-180z}{4.5}

which simplifying gives us, z=0.0589\Omega/m\approx0.06\Omega/m (which is our required solution)

putting the value of z in either (1) or (2) gives us, r = 0.5325 \Omega

You might be interested in
4. In a closed system consisting of a cannon and a cannonball, the kinetic energy of a cannon is 72,000 J. If the cannonball is
FromTheMoon [43]

Answer:

D an B

Explanation:

3 0
2 years ago
Read 2 more answers
Calculate the average speed and average velocity of a complete round-trip in which the outgoing 250 km is covered at 95 km/h fol
ser-zykov [4K]

To solve this problem we will apply the concepts related to the kinematic equations of linear motion. From them we will consider speed as the distance traveled per unit of time. Said unit of time will be cleared to find the total time taken to travel the given distance. Later with the calculated average times and distances, we will obtain the average speed.

PART A)

The time taken to travel a distance of 250km with a speed of 95km/h is

t = \frac{d}{v}

t = \frac{250km}{95km/h}

t = 2.63h

Time taken for the lunch is

t = 1h

The time taken travel a distance of 250km with a speed of 55km/h

t = \frac{d}{v}

t = \frac{250}{55}

t = 4.54h

The total time taken is

t = t_{outgoing}+t_{lunch}}t_{return}

t = 2.63+1+4.54

t = 8.17h

The average speed is the ratio of total distance and total time

v = \frac{250+250}{8.17}

v = 61.15km/h

PART B)

As the displacement is zero the average velocity is zero.

5 0
2 years ago
A father demonstrates projectile motion to his children by placing a pea on his fork's handle and rapidly depressing the curved
MariettaO [177]

Answer:

4.17 m/s

Explanation:

To solve this problem, let's start by analyzing the vertical motion of the pea.

The initial vertical velocity of the pea is

u_y = u sin \theta = (7.39)(sin 69.0^{\circ})=6.90 m/s

Now we can solve the problem by applying the suvat equation:

v_y^2-u_y^2=2as

where

v_y is the vertical velocity when the pea hits the ceiling

a=g=-9.8 m/s^2 is the acceleration of gravity

s = 1.90 is the distance from the ceiling

Solving for v_y,

v_y = \sqrt{u_y^2+2as}=\sqrt{(6.90)^2+2(-9.8)(1.90)}=3.22 m/s

Instead, the horizontal velocity remains constant during the whole motion, and it is given by

v_x = u cos \theta = (7.39)(cos 69.0^{\circ})=2.65 m/s

Therefore, the speed of the pea when it hits the ceiling is

v=\sqrt{v_x^2+v_y^2}=\sqrt{2.65^2+3.22^2}=4.17 m/s

5 0
2 years ago
Describe electrons.<br> Location:<br> Charge:<br> Mass
irga5000 [103]
Protons, neutrons and electrons. Both protons and neutrons have a mass of 1 amu and are found in the nucleus. However, protons have a charge of +1, and neutrons are uncharged. Electrons have a mass of approximately 0 amu, orbit the the nucleus, and have a charge of -1.
5 0
2 years ago
Read 2 more answers
What is the total energy q released in a single fusion reaction event for the equation given in the problem introduction? use c2
kkurt [141]

Answer:

4.3\cdot 10^{-12} J

Explanation:

The fusion reaction in this problem is

4^1_1H \rightarrow ^4_2He +2e^+

The total energy released in the fusion reaction is given by

\Delta E = c^2 \Delta m

where

c=3.0\cdot 10^8 m/s is the speed of light

\Delta m is the mass defect, which is the mass difference between the mass of the reactants and the mass of the products

For this fusion reaction we have:

m(^1_1H)=1.007825u is the mass of one nucleus of hydrogen

m(^4_2 He)=4.002603u is the mass of one nucleus of helium

So the mass defect is:

\Delta m =4m(^1_1 H)-m(^4_2 He)=4(1.007825u)-4.002603u=0.028697u

The conversion factor between atomic mass units and kilograms is

1u=1.66054\cdot 10^{-27}kg

So the mass defect is

\Delta m =(0.028697)(1.66054\cdot 10^{-27})=4.765\cdot 10^{-29}kg

And so, the energy released is:

\Delta E=(3.0\cdot 10^8)^2(4.765\cdot 10^{-29})=4.3\cdot 10^{-12} J

6 0
2 years ago
Other questions:
  • Mary takes 6.0 seconds to run up a flight of stairs that is 102 meters long. if mary's weight is 87 newtons, what power has mary
    7·2 answers
  • A boat takes off from the dock at 2.5 m/s and speeds up at 4.2 m/s2 for 6.0 s. How far has the boat traveled? Round your answer
    10·2 answers
  • student uses a magnet to move a 0.025 kg metal ball magnet exerts a force of 5N which causes the ball to begin moving what is th
    11·1 answer
  • A rectangular beam 10 cm wide, is subjected to a maximum shear force of 50000 N, the corresponding maximum shear stress being 3
    13·1 answer
  • Assume you are driving 20 mph on a straight road. Also, assume that at a speed of 20 miles per hour, it takes 100 feet to stop.
    11·2 answers
  • An experiment to measure the speed of light uses an apparatus similar to Fizeau's. The distance between the light source and the
    9·1 answer
  • In order to get a tree stump out of the ground, chains are connected to two trucks. One truck pulls with a force of 600 N to the
    9·1 answer
  • Of the three primary forms of subaerial volcanoes, ________ are large cone-shaped mountains that consist of alternating layers o
    5·1 answer
  • Reset the PhET simulation (using the button in the lower right) and set it up in the following manner: select Oscillate, select
    15·1 answer
  • Lasers are classified according to the eye-damage danger they pose. Class 2 lasers, including many laser pointers, produce visib
    15·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!