Answer:
A ferromagnetic material is a temporary magnet. The domains in a ferromagnetic material are randomly arranged. Under certain actions, the domains align in a particular direction and the material acts as a magnet. The actions that can cause alignment of domains in a ferromagnetic material are:
- rubbing the material against a magnet would cause the alignment of domains in the same direction as of the magnet.
- passing electricity around the material would generate magnetic field which would cause domains to align along the direction of the field.
- placing the material near a strong magnet would cause the alignment of domains in the direction of the field generated by the strong magnet.
Other actions like heating the material, placing the material in a magnetic field of opposite polarity and hitting the material would lead to demagnetization of the magnetic material.
Answer:

Explanation:
If the stone will reach the top position of flag pole at t = 0.5 s and t = 4.1 s
so here the total time of the motion above the top point of pole is given as

now we have



so this is the speed at the top of flag pole
now we have



now the height of flag pole is given as



<span>By algebra, d = [(v_f^2) - (v_i^2)]/2a.
Thus, d = [(0^2)-(15^2)]/(2*-7)
d = [0-(225)]/(-14)
d = 225/14
d = 16.0714 m
With 2 significant figures in the problem, the car travels 16 meters during deceleration.</span>
Energy can change form, but the total amount of energy stays the same.
Answer:
w = √ 1 / CL
This does not violate energy conservation because the voltage of the power source is equal to the voltage drop in the resistence
Explanation:
This problem refers to electrical circuits, the circuits where this phenomenon occurs are series RLC circuits, where the resistor, the capacitor and the inductance are placed in series.
In these circuits the impedance is
X = √ (R² + (
-
)² )
where Xc and XL is the capacitive and inductive impedance, respectively
X_{C} = 1 / wC
X_{L} = wL
From this expression we can see that for the resonance frequency
X_{C} = X_{L}
the impedance of the circuit is minimal, therefore the current and voltage are maximum and an increase in signal intensity is observed.
This does not violate energy conservation because the voltage of the power source is equal to the voltage drop in the resistence
V = IR
Since the contribution of the two other components is canceled, this occurs for
X_{C} = X_{L}
1 / wC = w L
w = √ 1 / CL