Answer:
by using formula F=ma which is m stand for mass a stand for acceleration. so 500kg × 2 ms^-2
Answer:
They two waves has the same amplitude and frequency but different wavelengths.
Explanation: comparing the wave equation above with the general wave equation
y(x,t) = Asin(2Πft + 2Πx/¶)
Let ¶ be the wavelength
A is the amplitude
f is the frequency
t is the time
They two waves has the same amplitude and frequency but different wavelengths.
Answer: C. The case on the inclined surface had the least decrease intotal mechanical energy.
Explanation:
First and foremost, it should be noted that the mechanical energy is the addition of the potential and the kinetic energy.
From the information given, it should be known that when the block is projected with the same speed v up an incline where is slides to a stop due to friction, the box will lose its kinetic energy but there'll be na increase in the potential energy as a result of the veritcal height. This then brings about an increase in the mechanical energy.
Therefore, the total mechanical energy of the block will decrease the least when the case on the inclined surface had the least decrease intotal mechanical energy.
Answer:
v_f = 17.4 m / s
Explanation:
For this exercise we can use conservation of energy
starting point. On the hill when running out of gas
Em₀ = K + U = ½ m v₀² + m g y₁
final point. Arriving at the gas station
Em_f = K + U = ½ m v_f ² + m g y₂
energy is conserved
Em₀ = Em_f
½ m v₀ ² + m g y₁ = ½ m v_f ² + m g y₂
v_f ² = v₀² + 2g (y₁ -y₂)
we calculate
v_f ² = 20² + 2 9.8 (10 -15)
v_f = √302
v_f = 17.4 m / s
Answer:
See the answer below
Explanation:
<u>Independent variable</u>: Type of drug (Mem-Reen or placebo)
<u>Dependent variable</u>: memories
<u>Experimental group</u>: The group that was given Mem-Reen
<u>Control group</u>: The group that was given placebo
<u>Constants</u>: Food, hours of sleep, memory test procedures.
The independent variable is an input variable that produces effects on the dependent variable. As the variable is changed, it produces different effects on the dependent variable.
The dependent variable is the actual variable that is measured during an experiment. It is the main purpose of setting-up of an experiment.
The experimental group is also referred to as the treatment group while the control group is the group that does not receive treatment at all or they receive fake treatment/placebo.
Constants are unchanging variables included in experiments. They remain unchanged both in the treatment and the control group, otherwise, the outcome of the experiment will be unreliable.