answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
MrRa [10]
2 years ago
9

Sir Lance a Lost new draw bridge was designed poorly and stops at an angle of 20o below the horizontal. Sir Lost and his steed s

top when their combined center of mass is 1.0 m from the end of the bridge. The bridge is 8.0 m long and has a mass of 2000 kg; the lift cable is attached to the bridge 5.0 m from the castle end and to a point 12 m above the bridge. Sir Lost’s mass combined with his armor and steed is 1000 kg.
Determine
(a) the tension in the cable and
(b) the horizontal and vertical force components acting on the bridge at the castle end.

Physics
1 answer:
zloy xaker [14]2 years ago
4 0

Answer:

The Tension T is 42120N

The Horizontal force component is 18322.2N

The Vertical force component is - 4729N

Explanation:

First, you have to find the angle between the drawbridge and the cable using sine and cosine rule. This will result in angle 44.2°. Hence, the angle between the horizontal axis and the cable will be 64.2° (44.2° + 20°).

Having done that, you apply two conditions of equilibrium.

1. THE VECTOR SUM OF ALL FORCES EQUAL ZERO.

∑Fx = 0

∑Fx = Rx - Tcos64.2 = 0

Rx = 0.435T

∑Fy = 0

∑Fy = Ry + Tsin64.2 - W - w = 0

W = 2000kg × 9.8 = 19600N

w =1000kg × 9.8 = 9800N

Ry + 0.9T = 29400N

Ry = 29400 - 0.9T

2. THE SUM TOTAL OF TORQUES EQUALS ZERO

Rx: τ = 0

Ry: τ = 0

T: τ = 5 × Tsin44.2

= 3.49T m

W: τ = 4 × 19600sin90

= 78400Nm

w: τ = 7 × 9800sin9

= 68600Nm

Note:

Rx = x component of Reaction force

Ry = y component of Reaction force.

T = Tension

W = weight of bridge

w = weight of Sir Lance a Lost and his steed

τ = torque

Note: The torque of Tension is counter clockwise while that of the weights is clockwise.

Hence,

∑τccw = ∑τcw

3.49T = 78400 + 68600

3.49T = 14700Nm

T = 147000/3.49

T = 42120N

Rx = 0.435 × 42120

Rx = 18322.2N

Ry = 29400N - (0.9×42120)N

Ry = 29400 - 34129

Ry = -4729N

Note: Ry being negative means that the hinge of the drawbridge exerts a downward force.

You might be interested in
A 250 GeV beam of protons is fired over a distance of 1 km. If the initial size of the wave packet is 1 mm, find its final size
Margarita [4]

Answer:

The final size is approximately equal to the initial size due to a very small relative increase of 1.055\times 10^{- 7} in its size

Solution:

As per the question:

The energy of the proton beam, E = 250 GeV =250\times 10^{9}\times 1.6\times 10^{- 19} = 4\times 10^{- 8} J

Distance covered by photon, d = 1 km = 1000 m

Mass of proton, m_{p} = 1.67\times 10^{- 27} kg

The initial size of the wave packet, \Delta t_{o} = 1 mm = 1\times 10^{- 3} m

Now,

This is relativistic in nature

The rest mass energy associated with the proton is given by:

E = m_{p}c^{2}

E = 1.67\times 10^{- 27}\times (3\times 10^{8})^{2} = 1.503\times 10^{- 10} J

This energy of proton is \simeq 250 GeV

Thus the speed of the proton, v\simeq c

Now, the time taken to cover 1 km = 1000 m of the distance:

T = \frac{1000}{v}

T = \frac{1000}{c} = \frac{1000}{3\times 10^{8}} = 3.34\times 10^{- 6} s

Now, in accordance to the dispersion factor;

\frac{\delta t_{o}}{\Delta t_{o}} = \frac{ht_{o}}{2\pi m_{p}\Delta t_{o}^{2}}

\frac{\delta t_{o}}{\Delta t_{o}} = \frac{6.626\times 10^{- 34}\times 3.34\times 10^{- 6}}{2\pi 1.67\times 10^{- 27}\times (10^{- 3})^{2} = 1.055\times 10^{- 7}

Thus the increase in wave packet's width is relatively quite small.

Hence, we can say that:

\Delta t_{o} = \Delta t

where

\Delta t = final width

3 0
2 years ago
Un tubo de acero de 40000 kilómetros forma un anillo que se ajusta bien a la circunferencia de la tierra. Imagine que las person
Darina [25.2K]

Answer:

82.76m

Explanation:

In order to find the distance of the steel ring to the ground, when its temperature has raised by 1°C, you first calculate the radius of the steel tube before its temperature increases.

You use the formula for the circumference of the steel ring:

C=2\pi r    (1)

C: circumference of the ring = 40000 km = 4*10^7m (you assume the circumference is the length of the steel tube)

you solve for r in the equation (1):

r=\frac{C}{2\pi}=\frac{4*10^7m}{2\pi}=6,366,197.724m

Next, you use the following formula to calculate the change in the length of the tube, when its temperature increases by 1°C:

L=Lo[1+\alpha \Delta T]         (2)

L: final length of the tube = ?

Lo: initial length of the tube = 4*10^7m

ΔT = change in the temperature of the steel tube = 1°C

α: thermal coefficient expansion of steel = 13*10^-6 /°C

You replace the values of the parameters in the equation (2):

L=(4*10^7m)(1+(13*10^{-6}/ \°C)(1\°C))=40,000,520m

With the new length of the tube, you can calculate the radius of a ring formed with the tube. You again solve the equation (1) for r:

r'=\frac{C}{2\pi}=\frac{40,000,520m}{2\pi}=6,366,280.484m

Finally, you compare both r and r' radius:

r' - r = 6,366,280.484m - 6,366,197.724m = 82.76m

Hence, the distance to the ring from the ground is 82.76m

4 0
2 years ago
The blue curve is the plot of the data. The straight orange line is tangent to the blue curve at t = 40 s. A plot has the concen
Sever21 [200]

Answer:

  0.00325 moles/liter/second

Explanation:

The tangent line has a slope of (y2 -y1)/(x2 -x1) = (0.35-0.48)/(40-0) = -0.00325.

The rate of the reaction is about 0.00325 moles/liter/second.

_____

This is the rate of decrease of the concentration of A.

5 0
2 years ago
Read 2 more answers
As shown in the figure below, a bullet is fired at and passes through a piece of target paper suspended by a massless string. Th
NikAS [45]

Answer:

M = 0.730*m

V = 0.663*v

Explanation:

Data Given:

v_{bullet, initial} = v\\v_{bullet, final} = 0.516*v\\v_{paper, initial} = 0\\v_{paper, final} = V\\mass_{bullet} = m\\mass_{paper} = M\\Loss Ek = 0.413 Ek

Conservation of Momentum:

P_{initial} = P_{final}\\m*v_{i} = m*0.516v_{i} + M*V\\0.484m*v_{i} = M*V .... Eq1

Energy Balance:

\frac{1}{2}*m*v^2_{i} = \frac{1}{2}*m*(0.516v_{i})^2 + \frac{1}{2}*M*V^2 + 0.413*\frac{1}{2}*m*v^2_{i}\\\\0.320744*m*v^2_{i} = M*V^2\\\\M = \frac{0.320744*m*v^2_{i} }{V^2}  ....... Eq 2

Substitute Eq 2 into Eq 1

0.484*m*v_{i} = \frac{0.320744*m*v^2_{i} }{V^2} *V  \\0.484 = 0.320744*\frac{v_{i} }{V} \\\\V = 0.663*v_{i}

Using Eq 1

0.484m*v_{i} = M* 0.663v_{i}\\\\M = 0.730*m

7 0
2 years ago
The Olympic record for running the 200m dash is 19.3 seconds. What is the average speed for this record?
Aloiza [94]
I think it’s c. if not i’m sorry!!
3 0
2 years ago
Other questions:
  • If the current in a wire increases from 5 A to 10 A, what happens to its magnetic field? If the distance of a charged particle f
    14·2 answers
  • Point charge A with a charge of +4.00 μC is located at the origin. Point charge B with a charge of +7.00 μC is located on the x
    12·2 answers
  • A particle leaves the origin with an initial velocity v → = (3.00iˆ) m/s and a constant acceleration a → = (−1.00iˆ − 0.500jˆ) m
    10·1 answer
  • Two large blocks of wood are sliding toward each other on the frictionless surface of a frozen pond. Block A has mass 4.00 kg an
    7·1 answer
  • in a race, Usain Bolt accelerates at 1.99m/s^2 for the first 60.0m, then decelerates at -0.266m/s^2 for the final 40.0m. what wa
    13·1 answer
  • An object initially at rest experiences a constant horizontal acceleration due to the action of a resultant force applied for 10
    15·1 answer
  • The drag force F on a boat varies jointly with the wet surface area A of the boat and the square of the speed s of the boat. A b
    15·1 answer
  • A record player turntable initially rotating at 3313 rev/min is braked to a stop at a constant rotational acceleration. The turn
    12·1 answer
  • A beam of unpolarized light with intensity I0 falls first upon a polarizer with transmission axis θTA,1 then upon a second polar
    6·1 answer
  • Use the idea of density to explain why the dead creatures sink to the seabed​
    9·2 answers
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!