The correct steps in lighting a Bunsen burner would be as follows: First, clean the area. Get rid of any flammable substances near the burner. Second, close the air supply Third, turn on the gas supply to the burner. Fourth, use a lighter to light the flame. Fifth, adjust the flow of air to control the flame.
Answer: The weight of the products should be the same after he mixes them.
Explanation: The law of the conservation of mass states that the mass of the products in a chemical reaction must equal the mass of the reactants. Even if the products are changed or rearranged, the products and reactants will still have the same mass
Answer:
Carbondioxide, water and ATP
Explanation:
The reaction is called aerobic respiration because oxygen from the air is needed for it to work.
Answer:
1210 grams
Explanation:
Message me for extra info.
snap- parkguy786
Concept:
<em><u>Latent Heat of Vaporization</u></em>: It is defined as the amount of heat required to change the state of mater without changing of its temperature.
From the given question, the temperature at the boiling point remained constant despite the continued addition of heat by the Bunsen burner. <em>Actually,</em> this amount of heat is used by water to break the intermolecular bonds between the water molecules in the form of latent heat that converts the liquid state of water into vapor state of water.
Hence, the correct option will be d.<u>The energy was used to break the intermolecular bonds between the water molecules. </u>