Answer:
3.1°C
Explanation:
Using freezing point depression expression:
ΔT = Kf×m×i
<em>Where ΔT is change in freezing point, Kf is freezing point depression constant (5.12°c×m⁻¹), m is molality of the solution and i is Van't Hoff factor constant (1 For I₂ because doesn't dissociate in benzene).</em>
Molality of 9.04g I₂ (Molar mass: 253.8g/mol) in 75.5g of benzene (0.0755kg) is:
9.04g ₓ (1mol / 253.8g) = 0.0356mol I₂ / 0.0755kg = 0.472m
Replacing in freezing point depression formula:
ΔT = 5.12°cm⁻¹×0.472m×1
ΔT = 2.4°C
As freezing point of benzene is 5.5°C, the new freezing point of the solution is:
5.5°C - 2.4°C =
<h3>3.1°C</h3>
<em />
The intended sense is that of a reaction that depends on absorbing heat if it is to proceed. The opposite of an endothermic process is an exothermic process, one that releases "gives out" energy in the form of heat
It is going to be too low because the mass mistakenly used is lower than the initial.
Answer:
The answer to be filled in the respective blanks in question is
3 and 1
Explanation:
So, we know that the formation of cabon-dioxide mole and that of Adenosin-Tri-Phosphate (ATP) moles will be in the ratio of 3:1 i.e., three carbon-di-oxide moles and 1 ATP mole.
Therefore, we can say that one pyruvate mole when passed through citric acid cycle and pyruvate dehydrogenase yields carbon-di-oxide and ATP moles in the ratio 3:1
The question is incomplete , complete question is:
Hydrogen, a potential future fuel, can be produced from carbon (from coal) and steam by the following reaction:
Note that the average bond energy for the breaking of a bond in CO2 is 799 kJ/mol. Use average bond energies to calculate ΔH of reaction for this reaction.
Answer:
The ΔH of the reaction is -626 kJ/mol.
Explanation:
We are given with:
ΔH = (Energies required to break bonds on reactant side) - (Energies released on formation of bonds on product side)
The ΔH of the reaction is -626 kJ/mol.
