All categories

2 years ago

The diagram shows the field lines near the poles, X and Y, of two magnets.

Physics

2 answers:

Basile [38]2 years ago

3 0

<em>Answer: I think it is C</em>

Explanation: sorry if it wrong

makkiz [27]2 years ago

3 0

Answer:

its A but sorry if wrong :)

Explanation:

You might be interested in

A physics student walks 100 meters in 80 seconds. The student stops for 30 seconds, and then walks 200 meters farther in 90 seco

Elan Coil [88]

Answer:

B i think is the answer

Explanation:

i feel like it is B because if you put them together and the answer is 1.5 so it is B

8 0

2 years ago

Electric current in a solid metal conductor is caused by the movement of what ?

Vlad1618 [11]

Electric current in a solid metal conductor is caused by the movement of electric charge. An electric current is the flow of electric charge. An electron current, the flow of electrons, contributes to an electric current since the electron 'carries' negative electric charge. The flow of ions also contributes to an electric current in, for example, the electrolyte of an electrochemical cell.

5 0

2 years ago

A policeman kicks in a door with a force of 4500 N. What force does the door apply to the policeman’s leg?

Soloha48 [4]

Answer:

-4500 N

Source: Brainly

The police officer must be angry 0_0

4 0

2 years ago

Assume that segment r exerts a force of magnitude t on segment l. what is the magnitude flr of the force exerted on segment r by

mrs_skeptik [129]

If we are talking on the force being exerted by a segment of a rope of lenght R on the right on a point M which is being also pulled from the Left by a segment of rope R as shown in the figure attached. Then we invoke Newton's Third Law:
"Any force exerted by an object (in this case a segment of the rope) also suffers a equal and opposite force".
If we pick $T_R=T$ whis is the tension exerted by the right segment then the left segment will also exert an equal and opposite force so we have that $T_L=-T$

8 0

2 years ago

A steel cable 1.25 in. in diameter and 50 ft long is to lift a 20-ton load without permanently deforming. What is the length of

Over [174]

Answer:

50.0543248872 ft

Explanation:

F = Load = 20 ton = $20\times 2000\ lb$

d = Diameter = 1.25 in

$L_1$ = Initial length = 50 ft

$L_2$ = Final length

A = Area = $\dfrac{\pi}{4}d^2$

Y = Young's modulus = $30\times 10^6\ psi$

Young's modulus is given by

$Y=\dfrac{FL}{A\Delta L}\\\Rightarrow Y=\dfrac{FL_1}{\dfrac{\pi}{4}d^2(L_2-L_1)}\\\Rightarrow L_2=\dfrac{4FL_1}{Y\pi d^2}+L_1\\\Rightarrow L_2=\dfrac{4\times 40000\times 50}{30\times 10^6\times \pi\times 1.25^2}+50\\\Rightarrow L_2=50.0543248872\ ft$

The length during the lift is 50.0543248872 ft

6 0

2 years ago