Answer:
Molecules are speeding up as boiling occurs.
Explanation:
We have three states of matter;solid liquid and gas. Substances are found in these different states of matter according to the degree of energy and velocity of its particles. Highly energetic particles moving at high velocities are found in the gaseous state. Less energetic particles moving at lesser velocities due to intermolecular forces are found in the liquid state while particles with the least degree of freedom are found in the solid state. Solid particles do not translate but can vibrate or rotate about a fixed position.
When a liquid boils, particles at the surface of the liquid acquire sufficient energy and escape the surface of the liquid. This is because, as energy is supplied in the form of heat during boiling, molecules acquire sufficient energy to speed up their molecular motion and escape the liquid surface as vapour.
Answer:
Ethynylcyclopropane is the stable isomer for given alkyne.
Explanation:
In order to solve this problem we will first calculate the number of Hydrogen atoms. The general formula for alkynes is as,
CₙH₂ₙ₋₂
Putting value on n = 5,
C₅H₂.₅₋₂
C₅H₈
Also, the statement states that the compound contains one ring therefore, we will subtract 2 hydrogen atoms from the above formula i.e.
C₅H₈ ------------(-2 H) ----------> C₅H₆
Hence, the molecular formula for given compound is C₅H₆
Below, 4 different isomers with molecular formula C₅H₆ are attached.
The first compound i.e. ethynylcyclopropane is stable. As we know that alkynes are sp hybridized. The angle between C-C-H in alkynes is 180°. Hence, in this structure it can be seen that the alkyne part is linear and also the cyclopropane part is a well known moiety.
Compounds 3-ethylcycloprop-1-yne, <u>cyclopentyne </u>and 3-methylcyclobut-1-yne are highly unstable. The main reason for the instability is the presence of triple bond in three, five and four membered ring. As the alkynes are linear but the C-C-H bond in these compound is less than 180° which will make them highly unstable.
Answer:
Explanation:
The expression for Clausius-Clapeyron Equation is shown below as:
Where,
P is the vapor pressure
ΔHvap is the Enthalpy of Vaporization
R is the gas constant (8.314×10⁻³ kJ /mol K)
c is the constant.
For two situations and phases, the equation becomes:
Given:
= 13.95 torr
= 144.78 torr
= 25°C
The conversion of T( °C) to T(K) is shown below:
T(K) = T( °C) + 273.15
So,
T = (25 + 273.15) K = 298.15 K
= 298.15 K
= 75°C = 348.15 K
So,
To be able to answer this equations, we must set given information. Suppose the reaction to yield NO is:
N₂ + O₂ → 2 NO
Next, suppose you have 1 g of each of the reactants. Determine first which is the limiting reactant.
1 g N₂ (1 mol N₂/ 28 g)(2 mol NO/1 mol N₂)= 0.07154 mol NO present
Number of molecules = 0.07154 mol NO(6.022×10²³ molecules/mol)
<em>Number of molecules = 4.3×10²² molecules NO present</em>
2C3H6 (g) + 2NH3 (g) + 3O2 (G) -> 2C3H3N (g) + 6H2O (g)
First off.. not a chem board.. but n e way.
This is a limiting reagent problem.
set it up as a DA problem.(Dimension Analysis)
Start with what you want.
you want Grams of acrylonitrile (C3H3N)
so start with that (Using ACL in place of Acrylonitrile.. just for ease of typing)
(g) = (53 g of ACL/1mol ACL) (2 mols ACL/2 mol C3H6)/ (1mol C3H6/42 grams) (15.0 grams)
solve that you wiill get grams of Acrylonitrile created by 15 grams oc C3H6 = 18.9g
Same setup for the two other reactants.
so i did it and for
oxygen I got 11.04 grams
and for Ammonia i got 15.29 grams
So the most you can make is 11.04 grams because if you have ot make any more .. you will have to get more O2 .. but since you have only 10 grams of it .. that is the most u can make in this reaction.
Both the other reactants are in excess.
rate brainliest pls
