All categories

2 years ago

An aircraft travels 1400 km at a speed of 700 km/h

Physics

1 answer:

dolphi86 [110]2 years ago

7 0

Answer:

Total time of flight= 3.6 hours

Speed of flight= 611.1 Km/h

Explanation:

Time taken when moving at 700 Km/h

Since speed=distance/time then time=distance/speed=1400 Km/700 km/h=2 hours

Time taken when moving at a speed of 500 Km/h

Time=800 km/500 Km/h=1.6 hours

Total time taken=2 hours+ 1.6 hours=3.6 hours

Total distance covered= 1400 Km+ 800 Km=2200 Km

Average speed=distance/total time taken=2200 km/3.6 hours=611.1 Km/h

Therefore, average speed is 611.1 Km/h

You might be interested in

A solid element that is malleable' a good conductor of electricity, and reacts with oxygen is classified as a

Finger [1]

1) metal
Even though metalloids are also conductors of heat and electricity, malleable they are not as good as metals.
Metals are very good conductors of electricity and heat. They are also very hard to touch. Noble gases and non metals are the exact opposite in physical and chemical properties. Metals readily react with oxygen.

5 0

2 years ago

Buffalo, New York, experienced a snowstorm November 13–21, 2014. Residents refer to the event as “Snowvember.” What was the like

scZoUnD [109]

I know you're probably done with this by now, but the answer is *Lake-Effect Snow*

5 0

2 years ago

Read 2 more answers

A box slides down a frictionless plane inclined at an angle θ ¸ above the horizontal. The gravitational force on the box is dire

DedPeter [7]

<h2>Answer: at an angle $\theta$ below the inclined plane. </h2>

If we draw the <u>Free Body Diagram</u> for this situation (figure attached), taking into account only the gravity force in this case, we will see the weight $W$ of the block, which is directly proportional to the gravity acceleration $g$ :

$W=m.g$

This force is directed vertically at an angle $\theta$ below the inclined plane, this means it has an X-component and a Y-component:

$W=W_{X}+W_{Y}$

$W_{X}=m.g.cos(\theta)$

$W_{Y}=m.g.sin(\theta)$

Therefore the correct option is c

6 0

2 years ago

Read 2 more answers

A charge Q is placed on the x axis at x = +4.0 m. A second charge q is located at the origin. If Q = +75 nC and q = −8.0 nC, wha

Stells [14]

Answer:

23.1 N/C

Explanation:

OP = 3 m , OQ = 4 m

$PQ = \sqrt{4^{2}+3^{2}}=5 m$

q = - 8 nC, Q = 75 nC

Electric field at P due to the charge Q is

$E_{1}=\frac{KQ}{PQ^{2}}=\frac{9\times 10^{9}\times 75\times 10^{-9}}{25}=27 N/C$

Electric field at P due to the charge q is

$E_{2}=\frac{Kq}{PO^{2}}=\frac{9\times 10^{9}\times 8\times 10^{-9}}{9}=8 N/C$

According to the diagram, tanθ = 3/4

Resolve the components of E1 along x axis and along y axis.

So, Electric field along X axis, Ex = - E1 Cos θ

Ex = - 27 x 4 / 5 = - 21.6 N/C

Electric field along y axis, Ey = E1 Sinθ - E2

Ey = 27 x 3 /5 - 8 = 8.2 N/C

The resultant electric field at P is given by

$E=\sqrt{E_{x}^{2}+E_{y}^{2}}=\sqrt{(-21.6)^{2}+(8.2)^{2}}=23.1 N/C$

3 0

2 years ago

Which changes in an electric motor will make the motor stronger? Check all that apply.

ollegr [7]

To make the motor turn faster we can:
(a) increase the current
(b) use stronger magnets
(c) push the magnets closer to the coil
(d) put an iron centre piece into the coil
(e) adding more sets of coils

8 0

2 years ago