Because its molecules can slide around each other, a liquid<span> has the ability to flow. The resistance to such flow is called the </span>viscosity<span>. For organic liquids, as the chain increases the viscosity increases as well due to the bonding that is present. Therefore, the ranking should be as follows:
</span><span>CH3CH2CH2CH2CH2CH2CH2CH2CH2CH3
</span><span>CH3CH2CH2CH2CH2CH2CH2CH3
</span><span>CH3CH2CH2CH2CH2CH3 </span>
Although the process varies slightly from one material to another, the general process is as follows:
1) Choose an appropriate container for the solid. This may be a petri dish or a beaker in which you want to prepare the solution of the solid or any other lab equipment.
2) Place the container on a mass balance, then turn the balance on. The mass balance will automatically zero-out the mass of the container, so that any mass that you add on the container will be the mass of the solid. Alternatively, you may first measure the mass of the empty container alone.
3) Add the solid using a lab spatula. The solid should be added more slowly when the reading on the scale comes close to the desired value.
4) Remove the container from the mass balance after the desired amount of solid has been added.
Answer: pH=12.69
Explanation:



Initial 0.12 0 0
Eqm 0.12-x x x
![K_a=\frac{[H^+][F^-]}{[HF]}](https://tex.z-dn.net/?f=K_a%3D%5Cfrac%7B%5BH%5E%2B%5D%5BF%5E-%5D%7D%7B%5BHF%5D%7D)
(neglecting small value of x in comparison to 0.12)

Moles of 



0.06 moles of NaOH will give 0.06 moles of ![[OH^-]](https://tex.z-dn.net/?f=%5BOH%5E-%5D)
Now
moles of
will be neutralized by
moles of
and
moles of
will be left.
Molarity of 
![pOH=-\log[OH^-]=-\log[0.049]=1.31](https://tex.z-dn.net/?f=pOH%3D-%5Clog%5BOH%5E-%5D%3D-%5Clog%5B0.049%5D%3D1.31)
pH = 14 - pOH= 14 - 1.31 = 12.69
94.20 g/3.16722 mL = 29.74 g/mL
The ratio of mass to volume is equal to the substance's density. Thus, 29.74 g/mL is the density of whatever substance it may be. Density does not change for incompressible matter like solid and some liquids. Although, it may be temperature dependent.
Flame colors are produced from the movement of the electrons in the metal ions present in the compounds. When you heat it, the electrons gain energy and can jump into any of the empty orbitals at higher levels Each of these jumps involves a specific amount of energy being released as light energy, and each corresponds to a particular color. As a result of all these jumps, a spectrum of colored lines will be produced. The color you see will be a combination of all these individual colors.