I would say the answer is C) because the thermal energy of the coffee going into the cup has to level out until the cup gets warmer and the coffee gets cooler, and they reach the same temperature.Meaning that the jug which has already been at the same temperature(we can assume based on the verbiage “the coffee was poured from the jug to the cup”) which would give the jug more thermal energy.
Answer:
His drives are neither precise not accurate
Explanation:
It is true that his drives are neither precise nor accurate.
Accuracy is the exactness of measurement. It is the closeness of measured values to the true values.
In this problem, the true value is 250 yards, the measured values are 190 yards, 195 yards and 187 yards.
We can conclude that these numbers are very far from the true values. By virtue of that, they are inaccurate.
Precision is the ability to reproduce a set of experimental values. It is the closeness of the measured values to one another.
Jared failed to replicate his measured values over the three trials and so, his readings are not precise.
Therefore, his measurements are both imprecise and inaccurate.
Answer : Below are three ways described in brief for improving the quality of indigenous soap.
1) Add virgin coconut oil which serves as a softener and betel leaf extract. It is used to improve the quality of soap as an antimicrobial agent.
2) Add activated charcoal black granules or powder to the soap, it removes maximum dirt from the skin.
3) Adding a filler which will increase the shelf life of usage of the soap will also improve its quality.
Answer : Total molecules that will be needed to visualize a single egg will be 78500 molecules of dye.
Explanation : As a single egg cell has an approximately diameter of 100 μm.
We can use this formula to calculate area of the cell membrane;
A = π 
;
We can take π as 3.14 and we get;
A = 3.14 X
Soving we get;
A = 7850 μ
Here we have to calculate the amount of dye molecules which will be needed for 10 fluorescent molecules / μ but;
here 1 μ = 7850 μ dye molecules.
Therefore, 10 fluorescent molecules will need;
7850 X 10 = 78500 molecules of dye.
Therefore, the answer is 78500 molecules of dye.
Answer:
d.) Microwave photons cause the molecules to increase their rotational energy states, whereas infrared photons cause electrons in the molecules to increase their electronic energy states.
Explanation:
Microwave: transitions in the molecular rotational levels
Infrared: transitions in molecular vibrational levels
UV/Visible: transitions in electronic energy levels.
