All categories

2 years ago

Convert to standard notation. 1.312 x 10^2

Chemistry

2 answers:

arlik [135]2 years ago

7 0

Answer: The answer would be 131.2

Explanation: How I got my answer is quite simple. In order for it to turn into standard notation, it would need to be turned into the answer of an equation. The equation here would be "1.312 x 10^2". 10^2 would be 100. Multiply 100 by 1.312 will make the decimal point move 2 times to the right, so it will end up in front of the 2. That would make the answer 131.2

I hope this info helps! :P

noname [10]2 years ago

6 0

The answer is 131.2 because you move the decimal point two places to the right

You might be interested in

Suppose you wanted to make a buffer of exactly ph 7.00 using kh2po4 and na2hpo4. if the final solution was 0.10 m in kh2po4, wha

OleMash [197]

Answer:- 0.138 M

Solution:- The buffer pH is calculated using Handerson equation:

$pH=pKa+log(\frac{base}{acid})$

$KH_2PO_4$ acts as a weak acid and $Na_2HPO_4$ as a base which is pretty conjugate base of the weak acid we have.

The acid hase two protons(hydrogen) where as the base has only one proton. So, we could write the equation as:

$H_2PO_4^-\rightleftharpoons H^++HPO_4^-^2$

Phosphoric acid gives protons in three steps. So, the above equation is the second step as the acid has only two protons and the base has one proton.

So, we will use the second pKa value. The acid concentration is given as 0.10 M and we are asked to calculate the concentration of the base to make a buffer of exactly pH 7.00.

Let's plug in the values in the equation:

$7.00=6.86+log(\frac{base}{0.10})$

$7.00-6.86=log(\frac{base}{0.10})$

$0.14=log(\frac{base}{0.10})$

Taking antilog:

$10^0^.^1^4=\frac{base}{0.10}$

$1.38=\frac{base}{0.10}$

On cross multiply:

[base] = 1.38(0.10)

[base] = 0.138

So, the concentration of the base that is $Na_2HPO_4$ required to make the buffer is 0.138M.

5 0

2 years ago

Select the valid ways to make an ammonia/ammonium buffer for use in the laboratory. Mix equal volumes of 1 M NH3 and 0.01 M NH 4

mrs_skeptik [129]

Answer:

The answer is "Option b and Option c".

Explanation:

This buffer is a buffer of ammonia and ammonium ion. Thus it requires the solution $NH_3 \ \ and \ \ NH_4^{+}$ .

In point 1:

The solution containing $NH_3 \ \ and \ \ NH_4^{+}$ at 1M concentration would be given by mixing the two solutions. Thus, this buffer is a legitimate route.

In point 2:

It gives the ions you want but they are not the same.

In point 3:

$1 M$ $NH_3$ and $1 M$ $HCl$ volume would not produce the same $NH_3 \ \ and \ \ NH_4^{+}$ concentrations. Therefore, this buffer isn't a valid route.

In point 4:

Some $1 M$ $NH_3$ volume and half $HCl$ . This offers the same rate as half.

7 0

2 years ago

How many moles of O2 would be required to generate 13.0 mol of NO₂ in the reaction below assuming the reaction has only 73.3% yi

Airida [17]

Answer:

Mmmmmmmmmmmmmmm

Explanation:

4 0

2 years ago

Question 2: Phase Changes (14 points) a. Rewrite each of the following equations for phase changes, to include the heat required

lilavasa [31]

Explanation:

(i) The equilibrium reaction equation will be as follows.

$H_{2}O(l) \rightleftharpoons H_{2}O(s)$

A reaction in which there will be absorption of heat energy is known as endothermic reaction.

A reaction in which there will be release of heat energy is known as exothermic reaction.

As liquid state of water is changing into solid state. So, it means that molecules of water came close to each other. Hence, there will be release of heat this means that reaction is exothermic in nature.

Hence, phase change from liquid to solid will be exothermic in nature.

Latent heat of fusion is defined as the amount of energy necessary to convert 1 gram of a solid into liquid state at its melting point.

So, when solid state of water changes into liquid state then it means energy is absorbed by the molecules of ice due to which they have gained kinetic energy. Hence, they moved away from each other leading to formation of liquid state of water.

Latent heat of freezing of liquid water is 334 J/g.

Specific heat of liquid water is 4.186 $J/g ^{o}C$

Specific heat of steam is 1.996 $kJ/kg/^{o}K$

Specific heat of ice is 2.1 $kJ/kg/^{o}K$

(ii) The equilibrium reaction equation will be as follows.

$H_{2}O(l) \rightleftharpoons H_{2}O(g)$

As liquid state of water is changing into gaseous or vapor state. So, it means molecules of liquid water has gained kinetic energy hence, they colloid more rapidly with each other.

As a result, heat will be absorbed by the liquid state of water. Hence, heat will be absorbed. Therefore, phase change from liquid to gas will be endothermic in nature.

Whereas when gaseous state of water will change into liquid state then heat will be released during this process of condensation. As a result, in that case reaction will be exothermic in nature.

5 0

2 years ago

In this lab, you will do experiments to identify types of changes. Using the question format you learned (shown above), write an

Vlad1618 [11]

Answer:

How can you distinguish a physical change from a chemical change?

Explanation:

4 0

2 years ago